Quick Start Installation and Configuration

Quick Start Installation and Configuration

Configuration Requirements

Determine the following information for performing the initial configuration.

• NetScaler IP address: The management IP address of the appliance.

• Subnet IP address or Mapped IP address: The IP address used by the appliance to represent the client when communicating with a server.

• Default gateway: The IP address of the router that forwards traffic out of the appliance’s subnet.

• Root password: The root user (nsroot) has full administrative privileges on the appliance. The root password is used to authenticate the root user.

Setting Up Connectivity

Connect the appliance to a management workstation or the network by using the NetScaler configuration utility, the command-line interface (CLI), or the LCD keypad.

Configuration Utility Setup

To set up the appliance by using the configuration utility, you need a management workstation or laptop configured on the same network as the appliance. To run the configuration utility, the Java RunTime Environment (JRE) version 1.4.2_04 or later must be installed on the workstation or laptop.

Note: The Setup Wizard automatically opens upon log on when the appliance is configured

with the default IP address, when licenses are not installed on the appliance, and when either

the mapped IP address or subnet IP address is not configured.

To configure the NetScaler by using the configuration utility

1. Connect the NetScaler to a management workstation or network.

2. Open a browser and type: http://192.168.100.1

Note: The NetScaler is preconfigured with the IP address 192.168.100.1.

3. In User Name, type nsroot.

4. In Password, type nsroot.

5. In the Setup Wizard, click Next and follow the instructions in the wizard.

6. To confirm that the NetScaler is configured correctly, you can either ping the new NetScaler

IP address (NSIP) or use the new NSIP to open the configuration utility in a browser.

CLI Setup

To set up the appliance by using the command-line interface (CLI), connect the serial cable to

the console port. Access the command line with a terminal or terminal emulator with the

following settings:

• Baud rate: 9600

• Data bits: 8

• Parity: None

• Stop bits: 1

• Flow control: None

Log on to the NetScaler with the following credentials:

User name: nsroot

Password: nsroot

To configure the NetScaler by using the NetScaler command line

At the NetScaler command prompt, type:

• set ns config -ipaddress<IPAddress> -netmask<subnetMask>

• add ns ip<IPAddress> <subnetMask> -type<type>

• add route Network<subnetMask> <gateway>

• set system user<userName> <password>

• save ns config

• reboot

LCD Keypad Setup

To set up the appliance by using the LCD keypad on the front panel of the appliance, enter the

following initial settings in the following order:

1. Subnet mask

2. NSIP

3. Gateway

The NSIP and the default gateway should be on the same subnet.

The subnet mask, NSIP, and gateway values are saved in the configuration file. You can then use the NSIP to connect to the appliance remotely. For more information, see the Citrix NetScaler Hardware Installation and Setup Guide at http://support.citrix.com/ article/ CTX132365.

Additional Information

A complete set of documentation is available on the Documentation tab of your NetScaler and from

http://support.citrix.com/. (Most of the documents require Adobe Reader, available at http://adobe.

com/ .)

To view the documentation

1. From a Web browser, log on to the NetScaler.

2. Click the Documentation tab.

3. To view a short description of each document, hover your cursor over the title. To open a

document, click the title.

If you have support questions, please contact Citrix Technical Support at 1-800-4-CITRIX (1-800-

424-8749). For additional contact information, see Support Phone Numbers at http://support.

citrix.com/. If you have comments or feedback on this documentation, please email to nsdocs_

feedback@citrix.com.